431621

The Sink Box series extruded aluminium Enclosure ideally suited for mounting small printed circuit boards or chassis horizontally. The enclosure body is formed from a single, hollow aluminium extrusion. This gives the unit high strength as well as simplifying assembly. The aluminium extrusion has fins on one side (the top) which act as a heat sink. Aluminium end panels are attached to each end. The interior of the enclosure contains numerous slots on both of the shorter sides to accept a PC board or chassis, three T slots which provide an alternative method of mounting chassis or components that need to be cooled by conduction, the single T slot in the top takes an M3 half-nut and the two T slots in the bottom take M4 half-nuts. The exterior of the enclosure contains heat sink fins across the entire top, two T slots on the bottom to allow mounting of wall brackets, belt attachment or to connect to another enclosure and the two bottom T slots take M4 half-nuts.

• Extrusions are anodized in a choice of either black or clear
• Moulded black plastic bezels which can be used to protect the end panels
• End panel assembly screws

Ứng Dụng

Industrial