MX25U6435FM2I-10G

MX25U6435FM2I-10G is 64Mb serial flash memory, which is configured as 8,388,608 x 8 internally. When it is in two or four I/O mode, the structure becomes 33,554,432 bits x 2 or 16,777,216 bits x 4. MX25U6435F feature a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus while it is in single I/O mode. The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output (SO). Serial access to the device is enabled by CS# input. When it is in two I/O read mode, the SI pin and SO pin become SIO0 pin and SIO1 pin for address/dummy bits input and data output. When it is in four I/O read mode, the SI pin, SO pin, WP# pin and Reset# pin become SIO0 pin, SIO1 pin, SIO2 pin and SIO3 pin for address/dummy bits input and data output. The MX25U6435F MXSMIO® (Serial Multi I/O) provides sequential read operation on whole chip.

• Power supply operation 1.65V to 2V for read, erase, and program operations
• Low power consumption, deep power down of 1.5uA(typ.)
• Clock frequency of 104MHz
• Typical 100,000 erase/program cycles, 20 years data retention
• Latch-up protected to 100mA from -1V to Vcc +1V
• Advanced security features enhance the protection and security functions
• Auto erase and auto program algorithms
• Support serial flash discoverable parameters (SFDP) mode
• Operating temperature range from -40 to 85°C